Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - reading burn patterns in chamber.
View Single Post
  #4 (permalink)  
Old 10-23-2010, 08:05 PM
turbolover turbolover is offline
Member
 
Last photo:
Join Date: Aug 2010
Location: Missouri
Posts: 466
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Its a head from a gx200 clone. It burned a head gasket so I took it off and was amazed there was no reversion (I did a lot of work to it but it was all "best guess"). It gets my gocart up to about 70 pretty quickly and about an hour of hard running per gallon. Ported and milled head, ported carb, cam, header are about all the mods so far. Am considering advancing the timing about 4 degrees. It was running a little rich but I swapped the jets so it should be close to spot on now.
Reply With Quote