Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Rear end swap
Thread: Rear end swap
View Single Post
  #1 (permalink)  
Old 03-17-2013, 04:20 AM
jim owens's Avatar
jim owens jim owens is offline
Registered User
 
Last photo:
Join Date: Apr 2011
Location: Taunton,Mass.
Posts: 35
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Rear end swap

I have a chance to buy a rearend out of a full sized 1993 Buick Estate wagon with a 3.23 posi, I was thinking about replacing my 8.2 ---3.08 "single tire fire" in my 2 door 67 Buick Skylark. Of course I will measure for drive shaft length/ yoke size/ axle to axle length etc.... Before I start pulling Both rearends out ---Is this do able, since there is a big difference in the years.
Thanks JIM
Reply With Quote