Ive posted on this before ,but it is so simple , I will do again. 2005 chev tahao rear bar is almost a bolt in. Remove the mounts from housing ,trim down . the end rods on the bar fit right to the factory frame holes. Bar sits over the diff.[foward] weld mount onto housing. enjoy
Mine is a 57 ranch wagon. I think it will fit most old fords surley thru 59 The bar is off of a 2005 chev tahao. The whole deal took less than 1hr !!
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Hot Rod Forum
2.2M posts
175.6K members
Since 2001
A forum community dedicated to hot rod owners and enthusiasts. Come join the discussion about restoration, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!