Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Removing heads
Thread: Removing heads
View Single Post
  #3 (permalink)  
Old 10-20-2008, 08:31 PM
DoubleVision's Avatar
DoubleVision DoubleVision is offline
Not Considered a Senior Member
 
Last photo:
Join Date: Oct 2002
Location: Heart Of Dixie
Age: 40
Posts: 10,658
Wiki Edits: 0

Thanks: 15
Thanked 60 Times in 57 Posts
I`ve seen in several cases where the rockers have to be clearenced so they don`t make contact. Usually a carbide cutter was used then checked and rechecked until enough clearence was created. Usually the contact shows up during the mock up assembly and all the rockers are checked. But I suppose it could have occured at a upper rpm blast. I can`t say I have heard of engine works stuff so I can`t give a opinion on them.
Reply With Quote