Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Replacing wood in body with steel
View Single Post
  #8 (permalink)  
Old 03-14-2013, 07:53 AM
timothale timothale is online now
Registered User
 
Last wiki edit: General Motors transmissions Last photo:
Join Date: Mar 2006
Location: near Yellowstone park
Posts: 4,323
Wiki Edits: 27

Thanks: 12
Thanked 255 Times in 239 Posts
steeling a body

we replaced the wood in my son's 22 dodge lakester and the 29 nash roadster. I used my old HF pipe bender and the round dies. I marked the sq tubing every inch and slid the pipe along each inch, with the round dies, just hold the tubing square, jack a little and watch the end move, then to the next spot, and work till it matches the patterns on a cardboard sheet. Cboy shows some dies he made to make tight radius bends in his eBook. here on hotrodders. He even made a large plywood "die" screwed to the side of his garage and a come-a -long to bend a long curve on one of his cars.
Reply With Quote