Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Rod Bearing Wear
View Single Post
  #12 (permalink)  
Old 03-20-2010, 01:51 PM
Plaintoast Plaintoast is offline
Registered User
 
Join Date: Oct 2008
Location: Mora,MN
Posts: 414
Wiki Edits: 0

Thanks: 0
Thanked 6 Times in 6 Posts
Quote:
Originally Posted by Tubbed357
Yes you are right about the thumper cams. There are better out there. The heads i have are some nice iron centerbolt heads with 64cc chambers. The valves are 1.94-1.5

Do you think it would be a bad idea to run 11:1 on these heads. Im going to get them milled very soon here so my chambers will be in the 58cc area. Also i do have high octane available at the pump right near me.
Any idea what the casting number is on those centerbolt heads?
Reply With Quote