Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - rolling sheet metal what tool?
View Single Post
  #5 (permalink)  
Old 04-27-2013, 05:40 AM
OneMoreTime's Avatar
OneMoreTime OneMoreTime is offline
Hotrodders.com moderator
 
Last wiki edit: Health and safety in the shop or garage
Last journal entry: Yard Dog pic
Last photo:
Join Date: Jul 2004
Location: Washington State
Age: 69
Posts: 7,313
Wiki Edits: 3

Thanks: 46
Thanked 146 Times in 138 Posts
The picture shows a homemade slip roll as the metal is going through the dies shown it assumes a curve..then you need to shrink the edges to make the crown of the fender..

Sam
__________________
I have tried most all of it and now do what is known to work..
Reply With Quote