Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Room for a speedo-cable on Muncie M20?
View Single Post
  #3 (permalink)  
Old 04-15-2013, 08:03 AM
John long's Avatar
John long John long is online now
Slow but willing learner
 
Last photo:
Join Date: Feb 2012
Location: Chattanooga, Tn
Age: 69
Posts: 2,170
Wiki Edits: 0

Thanks: 1,025
Thanked 1,352 Times in 1,096 Posts
Quote:
Originally Posted by 31ROC View Post
So, nearing completion of the tranny swap-(700R4 to Muncie M20). I currently have an electric speedometer, and the Muncie takes a mechanical cable. Just install the conversion kit right? So I bought one, and there's no room to fit it between the shift linkage. In fact, being a newbie at this, is there really any room for a mechanical cable? (Do I need to change the speedo to a mechanical?)
See attached photos.....
My knowledge here is very limited but I do know the pontiac speedo drive was on the passenger side of the tailshaft. Worse case scenario you could swap tailshaft housings. I am sure there is an easier solution but thought I would share that.
Reply With Quote