Rust on Piston Pin!!
Hey guys I have finally gotten around to putting my 383 SBC together. I bought an entire brand new rotating assembly about a year ago and had it stored inside. I have just started putting it together this week and low and behold..... RUST!! It doesn't look like a major concern but about 4 of my piston pins have very very minor surface rust spots on them. I have used very fine emery cloth and solvent to sand these small rust spots smooth. I can run my finger nail down all of the spots and it won't catch so I think it isn't a big problem and I am just overeacting. Please let me know if it is a concern or not, keeping in mind that my finger nail won't even catch on these spots now.
not a big deal as long as you got all the rust off.oil them so they dont rust again,next time be a little more careful (im being a wise a- -.(ive done the same thing) :) :) :) :) :)
Use steel wool and motor oil. It won't scratch the part like sandpaper will.
|All times are GMT -6. The time now is 02:09 AM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.