Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Sandblasting cabinet homemade
View Single Post
  #32 (permalink)  
Old 07-30-2010, 10:45 AM
Proton Proton is offline
Registered User
 
Join Date: Jul 2010
Location: Souht Africa
Posts: 4
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Quote:
Originally Posted by KenCam
I used PVC flanges for the arm holes. They were a tad small. I had planned to weld in something better later. I attached the gloves to the flanges with large hose clamps.
Hey there,

thanks for the reply, but what are PVC Flanges? and if they were too small, what do you think should one rather use... or where do you guys think one can find plastic arm holes like these?
http://www.alexdavisassoc.com/galler...st_cabinet.jpg

i would like to use something big so one has enough space to work and move..

any suggestions?
Reply With Quote