Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - SBC 350 Engine Advice needed
View Single Post
  #10 (permalink)  
Old 10-31-2012, 11:02 AM
Clayton A's Avatar
Clayton A Clayton A is offline
Registered User
 
Join Date: Oct 2012
Posts: 9
Wiki Edits: 0

Thanks: 1
Thanked 0 Times in 0 Posts
Cam Info

The cam that I have is a Crane Cam with 238 int / 244 exh @ 050 in lift with 0.502 int / .0516 exh lift lobe separation of 106 degrees. Now that I have the specifics on the cam lets say that the heads are just out of the box Vortec 12558062 heads with 1.94/1.50 valves with 64cc chambers. Would this be too much cam for these heads?
Reply With Quote