Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Sbc Valve stem seals
View Single Post
  #1 (permalink)  
Old 10-07-2012, 02:42 PM
boneyard Buick's Avatar
boneyard Buick boneyard Buick is offline
Member
 
Last photo:
Join Date: Oct 2004
Location: BC
Age: 28
Posts: 225
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Sbc Valve stem seals

Hey all
Been a few years since Ive played with a Sbc.
Recently dropped a 5.9 cummins into a 96 sierra crew so I've had my hands full.
I just put an 85 Sbc350 into an 84 s10 blazer, th475 HD trans. Bit of a family sleeper its just a standard bore, flat tops, mild cam, intake, edelbrock carb, dual 3" flowmaster super 40's.
Problem is shes pushing a little bit of blue on start up, the engine was my grandfathers he gave me before he passed and said the seals probably need doing. Other than that the heads have been off previously, full gasket kit.
So this is what I got from him. Can you guys tell me which belong on Intake/exhaust and where those rubber O rings go?
Lots of different styles Ive found on google
Thanks, I should know this but its been years!!

Im thinking blue/Intake brown/exhaust, but how are the O rings installed?

__________________
Ryan350 :thumbup:

Last edited by boneyard Buick; 10-07-2012 at 02:50 PM.
Reply With Quote