Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Searching for a source for a clutch pulley
View Single Post
  #1 (permalink)  
Old 03-10-2013, 03:09 PM
Chevelle406 Chevelle406 is offline
chevelle406.wordpress.com
 
Last photo:
Join Date: Mar 2013
Location: Manitoba, Canada
Posts: 14
Wiki Edits: 0

Thanks: 0
Thanked 2 Times in 2 Posts
Searching for a source for a clutch pulley

Just acquired a Brother LS2-B837 sewing machine in beautiful shape. Sews nice but for a rookie a bit on the fast side, especially when it starts.

I know, learn to use the machine the way it was designed. But, I think that for a start, it would be a lot easier to get the hang of it if I can slow it down.

The fun part of that is trying to find a source for the pulley on the clutch output shaft. Looking for a pulley around 2" or 50mm that will fit a 19mm shaft.

Does anyone know a good source preferably in Canada, if not then in the US. The only source that I have found so far is for a aluminum pulley in England.

One of the last repair shops for industrial sewing machines just closed in Winnipeg, so still trying to source a alternative.

I am sure that I will have a million more questions as this project continues.

Thanks for the help.
Reply With Quote