|
Well I just re-read this whole thread again. I was about to order the Consew servo motor but the Reliable is just too hard to beat plus it was on sale at Amazon so I ordered one. They are temporarily out of stock so I don't know when it will arrive. Soon I hope. I don't do a lot of upholstery work but it will be nice to be able to speed the learning curve.
I didn't learn to drive at 5 mph.....I think I did more burn outs and **** raising before I learned to drive sensibly..haha So now that I have successfuly sewed a finger and made a few other mistakes maybe I can slow down and do some serious learning. Sort of like putting it in drive and easing into the gas pedal instead of low gear and flooring it. haha
I'm look at doing my door panels, carpeting and trunk for starters.
Any good ideas for using the old clutch motor??? maybe a bench grinder??
|