Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Shaping convex body panels ....
View Single Post
  #2 (permalink)  
Old 11-27-2011, 02:28 PM
Sir Joab's Avatar
Sir Joab Sir Joab is offline
MOPAR Guy
 

Last journal entry: Restoration of my Chrysler
Last photo:
Join Date: Nov 2006
Location: Arlington WA
Age: 26
Posts: 187
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
I think for most of us this is a matter of feel... However, you could also take pieces of cardboard and cut one edge to fit up against the body (say, along those red lines on your picture) using the "good" side of the roof. Then lay on the filler a little too thick and sand down until the cardboard guide sits properly in place... homebuilt aircraft builders sometimes use this method for shaping wingtips.
Reply With Quote