Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - shaving handles
Thread: shaving handles
View Single Post
  #13 (permalink)  
Old 10-10-2004, 10:42 PM
Ron M's Avatar
Ron M Ron M is offline
Member
 
Join Date: Jul 2004
Location: Minnesota
Age: 50
Posts: 144
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
On some areas that I filled some quarter inch holes, the adhesive ended up slightly above the surface. I planned on grinding flush, DA and epoxy prime over. Is that going to be OK? I used 3M 8515 adhesive. Will it show down the road? The areas are on the side of the fenders and one on the roof post. After reading about movement on the last post, I wonder if this could be a real problem in a climate that goes from 100 to -30. I store my car in an unheated storage in the winter.
Reply With Quote