Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - shaving handles
Thread: shaving handles
View Single Post
  #23 (permalink)  
Old 10-13-2004, 06:03 AM
starquest starquest is offline
Member
 
Last photo:
Join Date: Mar 2003
Location: PA
Posts: 89
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Well I took a closer look at my 'screwup' last night. Turns out the whole area where the door handle was is now sunk 1/8" into the door! No matter what I do, I can't bang it out either! I really screwed up this one. I refuse to fill an 1/8" area with bondo on the viewable body of this car, not after all the hard work I put into it already. I think I am going to scrap the door. I hate to do it because this is a completely rust free door. However, the car in which this door came from was in an accident once before and it put a slight twist to the full door frame. So it also doesn't line up perfectly on my car, it is close but not perfect.

I have another rust free door stored at a friends house. I think I am going to start over on it, now that I learned something. Only bad thing is that I won't be able to pick up the new door until Thanksgiving.


Any thought to just leaving the shaved panels in tack welds rather than fully welding it up? With my welding ability, there is no way around a skim coat of bondo anyway, I just don't want to risk warping another door this bad again.


kev
Reply With Quote