Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Sheet metal Gauge?
Thread: Sheet metal Gauge?
View Single Post
  #2 (permalink)  
Old 09-10-2010, 04:36 PM
Rollinsmoke Rollinsmoke is offline
Registered User
  
Join Date: Jan 2010
Location: Northeas USA
Posts: 37
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Welding..
Not being smart or anything buddy but, if you are blowing through then you'll need to adjust the settings on your welder or adjust your welding methods/habits.

As far as that gauge goes I'm not sure but we normally use 16/18 some 11 gauge
Reply With Quote