|
|
|
|
#1
04-24-2009, 05:21 PM
|
||||
|
||||
|
92 SBC intake gaskets
I just picked up a new gasket set Felpro and I'm sure someone a whole lot smater than me can answer. On the 2 rear water cooling ports (L&R) the gasket is almost solid except there is about a 3/16-1/4 in. hole. I'm assuming that is restricting the water flow to make it go the proper way or hold it in the block longer. Bottom line I'm just curious as to the purpose and reasoning. Thanks, Eric
Register now (free) or login to remove ads 
|
|
#2
04-24-2009, 05:27 PM
|
||||||
|
||||||
|
You should have a heater port on the right rear corner of your manifold. These gaskets are designed to bleed air, and push the hot coolant into the heater core, instead of back through the engine block.
|
|
#3
04-24-2009, 05:38 PM
|
||||||
|
||||||
|
heater core hose port*
|
|
|
Back to top |
| Thread Tools | Search this Thread |
|
|
| Similar Threads for: "92 SBC intake gaskets" | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question on Pro Comp Heads on SBC and intake matching | y2k600f4 | Engine | 19 | 09-29-2008 05:55 AM |
| Removing intake on SBC... help! | v8hed | Engine | 14 | 06-06-2008 04:35 PM |
| SBC intake bolts | Cape Cod Bob | Engine | 3 | 05-27-2008 06:36 AM |
| SBC 283 intake & Carb Swap Problems | iceman_77 | Engine | 4 | 02-13-2007 05:49 PM |
| Intake gaskets | MHenricks | Engine | 0 | 02-08-2003 06:26 AM |
