Powdered rods. Standard bore with rods still attached. Full set with about 65k on them. All proceeds will go to hotrodders.com. This site has been helpful to me even before I joined but I don't have money to give, so you can have parts . Hope this helps. Sorry I do not know piston dish cc but I do know with a 58cc combustion chamber the CR was 10.5 to 1. These came out of a late model LT1. The rings are also still attached but I would replace if it were me.

Come on guys, somebody can use these. All proceeds are going to this board. Just trying to do my part. These will work in other small block chevys with a sandard bore. Same parts that GM now uses in their 350 crate engines.
These are flat top 4 vavle relief.

Check your PM box.

PM replied, best offer opening bid.

Ok, opening bid $5

I'll go $15. Hate to have to be so cheap.

Well I would say that this auction is done based on the amount of time it has been open. So you won Cobalt. Thanks for helping the cause.

I will get an actuall shipping qoute and PM you with it, but I think you actually pay the forum for the pistons and then I get confirmation that it is paid and ship them out to you.

OK, will keep an eye peeled for mail.

Thanks

Hey texas97z,

I just rec'd your PM, I sent PayPal payment for the pistons and rods today at ~12:30 am, 11-16-09.

The confirmation number is: 0N783899UY119672F.

I asked the donations director to notify you that payment had been made, I will await shipping charges from you and instructions for payment of same.

Thanks, cobalt327