Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Small Block Chevy valve lash
View Single Post
  #1 (permalink)  
Old 04-27-2012, 08:13 AM
Saito Saito is offline
Registered User
 
Join Date: May 2006
Location: PA
Posts: 79
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Small Block Chevy valve lash

When you hit zero lash (by spinning the pushrod, etc.) during adjustment of hydraulic lifters, how many turns on the nut do you go past that point to center the lifter plunger? I read 1/4 turn, 1/2 turn and even a whole turn. So which is it? I've seen varying accounts in both forum post and servive manuals. Thanks.
Reply With Quote