Thanks Fergie,however couldnt tell what type of lift mech you used,was it a linear actuator or struts,thanks again.
My problem is that Ive opted to leave the guards in one piece,so in doing so I have to allow front to travel 5" before it starts to tilt in order to clear the body(doors)
Any ideas that can assist me.....cheers brownie
I used Electric Linear Actuators and my fenders are cut; so mine tilts only. Yes, all will have to come forward 5" to clear before tilting; configuration unknown by me. All would somehow have to be mounted on a sliding/locking mechanism before tilting? There are a couple of threads on FordTruckEnthusiasts forum that address this issue if you care to search.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Hot Rod Forum
2.2M posts
175.7K members
Since 2001
A forum community dedicated to hot rod owners and enthusiasts. Come join the discussion about restoration, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!