Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Soda Blaster question
View Single Post
  #3 (permalink)  
Old 05-15-2009, 08:07 PM
eighty-one eighty-one is offline
Registered User
 
Last wiki edit: Health and safety in the shop or garage
Join Date: Jan 2009
Location: Buffalo, NY
Posts: 17
Wiki Edits: 3

Thanks: 0
Thanked 0 Times in 0 Posts
Quote:
Originally Posted by alittle1
You really didn't have to buy either soda blaster, you could have just sanded them down, primed and painted them, BUT, for your future information, the small 'spot' gun is for areas that are less than 6 X 6 inches,like around door handles, trunk lock bezels, while the other is for large surfaces like panels and bumpers. I guess you just wanted another tool!
Well, I don't have the patience to hand sand the bumpers, and I'm worried I'd get impatient or not pay close enough attention with my DA and sand a hole through the bumper!

BTW, I got too excited to leave that little spot gun in it's package, so I opened it up and gave it a shot with some Arm & Hammer. All it did was make a dusty mess So I guess I need to figure out if I need special soda, or if I just have the thing set up wrong, or what
Reply With Quote