Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - sonic test
Thread: sonic test
View Single Post
  #2 (permalink)  
Old 09-30-2012, 07:12 AM
BOBCRMAN@aol.com's Avatar
BOBCRMAN@aol.com BOBCRMAN@aol.com is offline
Member
 
Last photo:
Join Date: May 2002
Location: Holly, michigan
Posts: 7,951
Wiki Edits: 0

Thanks: 13
Thanked 218 Times in 207 Posts
Depends on the intended bore oversize. Check the block. Is the cam bearing bore well centered in the machined surface of the casting? If not, I would have block checked on anything over .040"
Reply With Quote