im sorry guys i dislike these threads too but im really inquiring on approxamitely what my next build will make.sorry again but here goes the specs.
781 or 049 heads
eddy perf rpm manifold
1 5/8 or so headers
quadrajet or around a 800 cfm eddy carb
compression ratio is probably low 9's
timing will be low at probably 10 or so degrees
another quick question would be: how do i determine how long my pushrods should be??
Thanks everybody,sorry about the"estimate my power" threads.
i am intrested in the torque FYI. my plan was a low-mid range motor(like my cam,2000-6200). Thanks all