[charliec]

A friend of mine ,that is a roofer , tells me that the sound deadening material such as dyna mat is nothing more than ice guard. I was wondering if anyone has used this, say inside of the door panels? It does look the same and a whole lot cheaper

[Henry Highrise]

It looks to me like it ought to do the job. Only one way to find out for sure and thats to give it a try.

[abuseddog]

A company called "secondskinadio.com" has a product that is superior and cheaper than dynamat it might be worth a look.

[302 Z28]

Any roofing supplier can get you or sell you a product called Peel and Seal. It is an adhesive backed aluminized butyl rubber material. I have used it and actually compared it to Dynamat and it appears identical. Lowes home improvement store also carries it but only in 6"x25' rolls. I purchased a 36"x30' roll from a Mobile home manufacturer for $89 plus shipping. Most of the high dollar products marketed for insulation for street rods are nothing more than commercially available products that have 200% to 500% price markup and repackaged to make them look like they are made specifically for street rodders.

Vince

[gator412]

I installed ice shield in my truck about 10 years ago. I attached a pic I just went out and took. I am getting ready to redo the truck and I will put ice shield on it again. I put one layer on the back cab wall and two on the floor. It made a big difference in the heat and sound in the cab...all for the better.

[abuseddog]

I'm going to home depot and check this stuff out!!

[302 Z28]

Here is the link for ordering Peel and Seal.

Vince

[charliec]

I think I will try the peel and seal. Thanks to everyone

[hotrodf1]

Check this out:

interior insulation

a great thread for sound deadner , lots of alternatives, etc.

[pepi]

[ Most of the high dollar products marketed for insulation for street rods are nothing more than commercially available products that have 200% to 500% price markup and repackaged to make them look like they are made specifically for street rodders.

Vince[/QUOTE]

This sounds about right, have seen similar things like this, it really pays to look close at products........................... nice catch and I might say perfect timing for my project are you reading my mind ................. not possible I do not have one......... LOL

[plymouth_man]

I have used the ice shield on my cars,and I like what it does and costs. To form it around or over humps,if doing the floor,you can use a plumbers torch to get it more pliable. I have also used 3-m adhesive to make it bond better to the doors.