Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - source for mopar flat head 6 performance parts
View Single Post
  #4 (permalink)  
Old 09-18-2011, 09:12 AM
hkestes's Avatar
hkestes hkestes is offline
48 Plymouth Club Coupe
Last photo:
Join Date: May 2009
Location: Plano, TX
Age: 56
Posts: 102
Wiki Edits: 0

Thanks: 0
Thanked 19 Times in 15 Posts
Thanks helrazr3, I have always been a Mopar guy and over the past 4-5 years have gained a bit of knowledge / info on the flatheads. They are really a pretty good power source and Mopar produced them virtually uchanged up through the early 70's for use in industrial applications, so parts are readily available at NAPA, Autozone, Tractor supply/repair facilities. They were used a lot in fork trucks, airport tugs, irrigation pumps, combines, tractors etc.

Need to make one revision to the info I provided after reading through it again.

On my post above the reference to the Borg Warner R10 OD should say from a mid to late 50's Plymouth or Dodge.
Reply With Quote