|
|
|
06-26-2012, 07:23 PM
|
|||||
|
|||||
|
speedway spindles issue...help
I recently purchased a set of 37-48 Ford spindles from speedway motors. When I took them to the machine shop, the machinist observed them to be defective (not seating right on the axle/ground down un even). Has anyone had an issue with them before? Is speedway motors pretty good about replacing them? Thanks!
|
|
06-26-2012, 08:00 PM
|
|||||
|
|||||
|
I have had very good luck with Speedway, they are good folks, I'd give them a call.
|
|
06-27-2012, 12:00 PM
|
|||||
|
|||||
|
Quote:
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Speedway Museum | V8Square | Hotrodders' Lounge | 3 | 05-06-2012 04:33 PM |
| Best 60s Issue of Hot Rod Magazine and best 50s Issue of Car Craft | MXrider13 | Hotrodders' Lounge | 18 | 07-29-2011 01:55 PM |
| Anybody used Speedway Fiberglass? | 327NUT | General Rodding Tech | 6 | 05-18-2010 09:25 AM |
| Speedway Products | mightycarlo10 | Engine | 6 | 01-04-2008 09:46 AM |
| Speedway | Derkyb | Garage - Tools | 8 | 07-10-2007 07:53 AM |
