Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - starter brace
Thread: starter brace
View Single Post
  #1 (permalink)  
Old 06-16-2010, 12:25 PM
Oldguy48 Oldguy48 is offline
Registered User
Last photo:
Join Date: Jul 2008
Location: Northeast PA
Posts: 253
Wiki Edits: 0

Thanks: 42
Thanked 43 Times in 31 Posts
starter brace

I've searched but have had no luck so far. I'm putting together a SBC (Gen 1), and just purchased a rebuilt starter for it. 168 tooth, staggered bolt pattern. I have a GM starter brace, but the starter is too long for the brace I've got. The starter is a DL3510MS from Autozone. Apparently the starter is a heavy duty unit that's a bit longer than the standard duty starter, and the brace I've got is for a standard duty starter. Does anyone know where I can obtain the proper brace for this. I'll fab one if I have to, but I'd rather purchase the correct part. Thanks for any help you can provide.
Reply With Quote