|
|
|
06-11-2006, 07:31 AM
|
|||||
|
|||||
|
Steering Column fm 78 Chev Van
Was luck to find a tilt column from a 78 van for my 49 3600 conversion. However the turn signal stalk broke off as it was bent a few to may times.
Question is do NON Cruise control stalks work in the place of the one that I have that has a button for cruise. I can find one with the button, but so far it's over a $100. @ Classic Ind. and that seems a little pricey. LD 49 3600 (in Progress) 58 Bel Air 
|
|
06-11-2006, 12:56 PM
|
|||||
|
|||||
|
Yes they should work. The only difference between the cruise control turn and non-cruise control turn; is the cruise control has a wire which runs down the column to the wiring harness. The cruise control turn comes out very easy, just pull the wire out. Then replace with any turn signal, you could probably get a cheep one at the scrap yard.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 57 Chev Dash and Steering column paint | kzgysr | Interior | 6 | 05-22-2006 02:01 PM |
| Steering Column Suggestions needed for 49 Chev PU | lazydawg | Suspension - Brakes - Steering | 7 | 08-12-2005 08:58 AM |
| Rebuilding Chevy Van steering column | Sly's 53 Suburban | Suspension - Brakes - Steering | 5 | 02-14-2005 07:43 AM |
| steering column on my 55 chev | fiftyfive | Suspension - Brakes - Steering | 1 | 11-18-2003 02:03 PM |
| GM Van Steering Column | BillyBob1950 | Suspension - Brakes - Steering | 3 | 04-01-2003 10:54 AM |
