Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Stock SBC pushrod length?
View Single Post
  #8 (permalink)  
Old 03-17-2012, 12:24 PM
chucksrt chucksrt is offline
Registered User
 
Last photo:
Join Date: Oct 2010
Location: Bensalem, Pa
Posts: 269
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
I have been reading all sorts of pages on this. I found that the wear pattern should be no bigger than .060-.080 wide on the tip of the valve. I haven't measured mine yet , it looks centered but I keep hearing to have a narrow pattern. I want to triple check the mark just to be safe.
Reply With Quote