Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Stock SBC pushrod length?
View Single Post
  #9 (permalink)  
Old 03-19-2012, 04:51 AM
Richiehd's Avatar
Richiehd Richiehd is offline
JS-70
 
Last photo:
Join Date: Jun 2011
Location: Jupiter FL
Posts: 831
Wiki Edits: 0

Thanks: 145
Thanked 55 Times in 48 Posts
Quote:
Originally Posted by chucksrt
I have been reading all sorts of pages on this. I found that the wear pattern should be no bigger than .060-.080 wide on the tip of the valve. I haven't measured mine yet , it looks centered but I keep hearing to have a narrow pattern. I want to triple check the mark just to be safe.
Sorry, you didn't say it was a roller, I assummed, my bad.
Pattern looks good, shortest pattern, in the center of the valve.
Reply With Quote