Is a 700r4 kick down correction bracket required on the holley STREET AVENGER carb to get the correct geometry ?
I have the proper cable bracket ( Holley #20-95 )

Thanks , Roger

Here is the one I have on mine, it works great. I don't remember which one it is, but I found out the geometry is incorrect using just the Street Avenger bracket.

Vince

__________________
Here's to you DoC, you will always be here.
My project 34
http://www.hotrodders.com/forum/34-...ght=34+progress

Thanks Vince,

Thats the one I got on my street avenger (holley #20-121), yours is the street avenger , right ? Just wanted to make sure it is required.
Do you have any pre-load on your TV cable at idle , like say bout 3/8"

Did u see my mods to my governor on previous post?
I will report on those results later, still up on stands.

Thanks again , Roger

Yes, it's Street Avenger 670cfm. My TV cable has a little preload, what you want to make sure of is that it is pulled all the way out at WOT.

I did see your post on the gov mod, waiting for your feedback. The Vette gov got me in the ballpark, but I would like another 1000 rpm before shifting into 2nd under WOT.

Vince

__________________
Here's to you DoC, you will always be here.
My project 34
http://www.hotrodders.com/forum/34-...ght=34+progress