Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Street Beast builds......Tips, problems and solutions.
View Single Post
  #331 (permalink)  
Old 12-03-2012, 01:22 PM
ProStreetCamaro ProStreetCamaro is offline
Registered User
 
Last photo:
Join Date: Feb 2012
Posts: 10
Wiki Edits: 0

Thanks: 1
Thanked 0 Times in 0 Posts
Hey guys we picked up this 98% completed fiberfab 34 earlier this summer. It needs a new master cylinder and booster. I can not for the life of me figure out which one was used on the car. It is a nice setup and I would like to replace it with the same thing. Anybody have any idea what this came off of? It is very similar to a mustang II booster and master but the 4 bolt holes that mount it to the firewall appear to be in the wrong locations and the brake lines on a mustang II setup go in the master cylinder on the outside of the master instead of the inside engine side like the one that is on the car now.


Reply With Quote