Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Sub Frame swap in
View Single Post
  #4 (permalink)  
Old 01-30-2002, 12:07 PM
F-1 Rodder F-1 Rodder is offline
New Member
 
Join Date: Jan 2002
Location: Seattle
Posts: 28
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Post

The frame clip requires a lot of patience and measurement before you pull out the torch, but if you leave the beer behind and go about it very carefully, you can do it. There have been many magazine articles on the process. Additionally, there are some weld in kits available. One that comes to mind is sold by RB's Obsolete from their catalog. Many of the weld in's use Must II components which provide a lot of flexability.
Reply With Quote