Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Summit Engine stand
View Single Post
  #26 (permalink)  
Old 11-01-2006, 08:34 PM
Mustangsaly's Avatar
Mustangsaly Mustangsaly is offline
Member
 
Last photo:
Join Date: Jan 2005
Location: Nebraska
Posts: 1,071
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Quote:
Originally Posted by ict55chevy
if the top bolt mount is at a different hole in the back of the block, say down a hole or two it would make a difference in the twist effect on the plate, at least that is my opinion.

tc

if this is my engine stand your talking about. my son hung it and did not take the time to center everything as I do so it turns over easier, but this was hung to get painted and not turned over so I left it. but I explained it to him.





Mustangsaly
Reply With Quote