Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - T400, looking for answers before install!
View Single Post
  #2 (permalink)  
Old 03-15-2013, 09:16 PM
SSedan64's Avatar
SSedan64 SSedan64 is offline
Registered User
 
Last photo:
Join Date: Dec 2007
Location: Macon, GA.
Age: 50
Posts: 6,016
Wiki Edits: 0

Thanks: 0
Thanked 46 Times in 46 Posts
Generally .010" clearance per Friction.
Some Forwards use 4 Frictions some use 5. Should be fine.

Pour 1qt. in TC/Torque Converter, pour 4qt. in Pan, with Rear on Jackstands start engine, shift thru gears, add fluid until it shows on the Dip stick, shift thru gears, add fluid untill it's at the Cold Mark, top off to Hot Mark when the Engine/Trans is up to operating temp.

Automatic Transmission & Torque Converter Fluid Capacity - TCIŽ Auto

Torque Converter Installation Instructions
Reply With Quote
The Following User Says Thank You to SSedan64 For This Useful Post:
JTraik (03-17-2013)