Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - tailshaft uni angles
View Single Post
  #1 (permalink)  
Old 03-02-2012, 02:33 AM
theg's Avatar
theg theg is offline
Registered User
 
Last photo:
Join Date: Nov 2010
Location: australia
Posts: 62
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
tailshaft uni angles

Hello to everybody .

Im fitting a 350 chev and turbo 400 into a custom 6 wheeler (picture of the rear axle assembly is in my profile ) Im not driving a front diff (6wd) only the twin rear axles .
My question for discussion is ; The rear diff driven buy the tailshaft from the gearbox is offset by several possibly around 6 inches to one side (ex 4wd) and the rear of the gearbox is centre of car .
Will this cause any problems as I notice virtually all 4wd vehicles have the gearbox flange in line with the diff pinion flange .

Last edited by theg; 03-02-2012 at 02:39 AM.
Reply With Quote