TBI vortec problems
finally got the vortec swapped in my truck(stock except for performer RPM intake and headers), well, the motor pops under slight throttle and is basically undrivable(305 poped before but wasnt as bad right after headers & new exhaust was installed). I think its possible that the computer may of been damaged when the shop welded on the exhaust, but know that the chip needs to be reburned. what else could possibly cause this?
BTW;what software would be the best to program, ive already got a OBD1 cable to laptop coming.
also, the egr isn't on the motor and the vaccum port on the tbi is pluged.
Last edited by 11secmudtrk; 12-14-2004 at 06:25 PM.