Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Tool to install crank sprocket on a SBC?
Thread: Tool to install crank sprocket on a SBC?
View Single Post
  #4 (permalink)  
Old 06-29-2008, 07:33 PM
CNC BLOCKS NE CNC BLOCKS NE is offline
CNC Blocks Northeast
  
Last photo:
Join Date: Sep 2006
Location: NORTHEAST
Age: 53
Posts: 1,342
Wiki Edits: 0

Thanks: 0
Thanked 7 Times in 7 Posts
We use a propane torch warm the gear up it will slide right on. We just had a crank in the shop to balance that some beat the gear on with a punchm Ahh we got a good laugh out it any ways.
Reply With Quote