Hot Rod Forum : Hotrodders Bulletin Board

Hot Rod Forum : Hotrodders Bulletin Board (http://www.hotrodders.com/forum/)
-   Transmission - Rearend (http://www.hotrodders.com/forum/transmission-rearend/)
-   -   Torque Converter Stall Speed (http://www.hotrodders.com/forum/torque-converter-stall-speed-108464.html)

Sir Joab 02-06-2007 11:00 AM

Torque Converter Stall Speed
 
Here's my question: is a 3000 RPM stall torque converter considered "streetable"? What stall speed defines the difference between a street and a strip car? :confused:

briscoe 02-06-2007 11:32 AM

Torque converter Stall speed
 
There are a lot of hot rods running on the street with 3000 stall speed converters. Some of them need this much stall,some of them don't.

Careful consideration,a little research,advice from your engine builder,or camshaft supplier,is important,when choosing how much stall you need,and can utilize.

Sir Joab 02-06-2007 04:40 PM

re: Torque Converter Stall Speed
 
Thanks briscoe! :thumbup:

xntrik 02-07-2007 03:42 PM

I think that the term streetable is relative to one's personal threshold of ridiculousness.

There are 9 and 10 second "race cars" street driven every day that I wouldn't ride across a parking lot in them. Just look at the "real street car drag challenges". Drive 30 miles in traffic and then drag race. The drive is a bigger challenge than the drag races. I would not drive one of these 5 miles to work every day, but some people do.

Roaring around with 4" Flowmasters and a 5000 stall getting 4 mpg is not my idea of a street car.

I drive a Lincoln TownCar :thumbup: and make straaange tire noises with my rods. :D But, hey, I'm over 35 now and the last ticket goes off my record next month. ;)


All times are GMT -6. The time now is 01:02 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.