Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Troubles with SBC 350 rebuild
View Single Post
  #19 (permalink)  
Old 10-21-2009, 08:33 AM
GMC boogie's Avatar
GMC boogie GMC boogie is offline
Last photo:
Join Date: Nov 2004
Location: Louisiana
Age: 51
Posts: 774
Wiki Edits: 0

Thanks: 5
Thanked 47 Times in 42 Posts
Originally Posted by k-star

It is not the cam bearings. In order to expose the groove in a chevy that bearing would need to be 1/2 ways out the bore. It would have stuck out like a sore thumb when you were putting it together.

Yes,would be pretty obvious on the first four,not so on the rear cam bearing...seen it before due to careless installation. Groove barely exposed but enough to leak.....was not that obvious due to the depth of the bore back there.
Reply With Quote