Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - trying to put on new valve seals SBC 350
View Single Post
  #1 (permalink)  
Old 09-22-2007, 06:37 PM
Ed ke6bnl Ed ke6bnl is offline
Member
 
Last photo:
Join Date: Feb 2002
Location: Agua Dulce Calif.
Posts: 328
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
trying to put on new valve seals SBC 350

I picked up some umbrella comp cam seals for my about 1980 350 chevy. The pulley type spring compressor was of junk replace one valve seal but when we tried to do the other the spring would not slide down the valve to be able to release the keepers. the first on the seal was like stone and would let us slide the spring off after getting the keeper off. the intake on #1 was worse and when we tried to slide the compressed spring down the valve would just open against the air pressure. Not going to attempt it till I have a better compressor . But any suggestions to getting the spring down with those baked on seals that are on there. Thanks ED

like spring compressor on the very top of page

http://images.google.com/imgres?imgu...%3Den%26sa%3DN
http://images.google.com/imgres?imgu...%3Den%26sa%3DN
Reply With Quote