Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Tube or pipe bender?
View Single Post
  #5 (permalink)  
Old 02-14-2010, 12:15 PM
Eddie Paul Eddie Paul is offline
Registered User
 
Last photo:
Join Date: May 2006
Location: El Segundo, CA
Posts: 19
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
the difference

Quote:
Originally Posted by Mikey_mike
Hey guys,
I was wondering if there is any difference in between a "pipe bender" and a "tube or tubing bender".
the tube is measured by the O.D. the pipe is measured by the I.D. so the dies are different sizes. but you can bend either on a good machine if you have the corect dies.
Eddie Paul
Reply With Quote