Hello i want help in tuning my Blower 388 SBC, aluminium heads (Edelbrock 6061) , 8.0:1 CR, hydraulic roller camshaft (Crane Cams 119661), all forged, @6psi of boost, Holley TBI Fuel injection
Fuel Table, I know i'm on the very rich side(security), but how far can i lean it?, what about 11.5 A/F Ratio?
Timing Table, what you think about this?, can I give a little more timing? or i'm in the limit?
PD: I Run the engine on 2000-3000ft elevation, is for sand hill climb on a 4000lb offroad Jeep
Regards
Fuel Table, I know i'm on the very rich side(security), but how far can i lean it?, what about 11.5 A/F Ratio?
Timing Table, what you think about this?, can I give a little more timing? or i'm in the limit?
PD: I Run the engine on 2000-3000ft elevation, is for sand hill climb on a 4000lb offroad Jeep
Regards