Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Twin I-beam Ford front axels used on street rods
View Single Post
  #4 (permalink)  
Old 11-21-2012, 03:30 PM
matt167 matt167 is offline
Member
 
Last wiki edit: Ford axle ratio codes
Last journal entry: Rear Suspension
Last photo:
Join Date: Aug 2005
Location: Prattsville
Posts: 6,415
Wiki Edits: 31

Thanks: 2
Thanked 61 Times in 57 Posts
The pre '81 beams can be heated and bent. After '81, beams were cast and not forged and cannot be bent. I used the entire front frame from a 1994 Ford Ranger ( Twin I beam ) on my scratch built, rather than fabricate my own frame. It would have been tough to figure out the angles.
Reply With Quote