Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - which type of welding helmet is best?
View Single Post
  #7 (permalink)  
Old 02-18-2013, 08:05 AM
timothale timothale is online now
Registered User
 
Last wiki edit: General Motors transmissions Last photo:
Join Date: Mar 2006
Location: near Yellowstone park
Posts: 4,473
Wiki Edits: 27

Thanks: 13
Thanked 285 Times in 265 Posts
cheater lens

The magnifing "cheater lens" doesn't fit into any of my auto dark helmets. I had to duct tape it into one I use for more accurate work. I was into the welding supplier the other day and he now stocks a plastic adaptor that holds the lens. but for $ 7.00 I said I would have to bring in a helmet and make sure it would fit.
some one needs to make a "FAT head" welding helmet. large enough so I can wear a thick insulated cap when I am out welding when it's well below , ZERO *
PS, I use my hair dryer type heat gun to warm up the helmet, so it won't fog up for a few minutes, just hold it back far enough to not melt any plast parts

Last edited by timothale; 02-18-2013 at 08:15 AM.
Reply With Quote