Ok, I'm just about to the end of my mechanical list. I have two little incidentals left. AC conversion and trans harness, no big deal.
I am taking care of it this week. Now it's time to start under the hood.
So...here's my question..
I'm thinking of doing a custom made cover (not that catalog crap) that would tie into the valve cover screws on the bottom, and the fuel rail screws on top. I'm thinking .050 black anodized aluminum. Maybe have something lazer etched into them. C4 Corvette Logo? Injectors Plus Logo (tax write off), maybe just a design. Or nothing, may conflict with the valve covers.
What do you guys think? I'd wrap around the end of the valve covers, and cover the ends of the fuel rails, leaving the center of the fuel rails showing.
There's a lot going on there I thought it would clean it up a whole bunch.