Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - used my new trimmers table today pics attached
View Single Post
  #42 (permalink)  
Old 01-30-2011, 01:53 PM
stumpy1972uk1's Avatar
stumpy1972uk1 stumpy1972uk1 is offline
newbie
 
Last photo:
Join Date: Oct 2009
Location: united kingdom
Age: 42
Posts: 93
Wiki Edits: 0

Thanks: 1
Thanked 1 Time in 1 Post
Quote:
Originally Posted by Coodeville
Where you stitching real slow when you did the diamonds?
I tacked the foam to the vinyl with spray adhesive, then marked ourt the diamonds , then starting at the middle line worked my way outward , working at a medium speed , I'm strange I find going slow tends to drift off line , once the first set of lines are done I started the other set which then creates the diamonds, I found it necessary to press down on the diamonds either side if the presser foot when going across the first set of lines .
I have cut a small groove in the front facing edge on the foot and white lined it, that allows me to see where the footsteps going, thanks again to Dan two lakes for this tip. Ade
Reply With Quote