|
|
|
02-21-2012, 07:18 PM
|
||||
|
||||
|
valve to piston clearance
Hey guys i have been working on building my 352 fe. it is bored .020 over and i am going to get a lunati cam with about .580 lift and 290 duration and some sealed power pistons. but i am nervous about valve to piston clearance. do you think i will have any issues? any help would be great THANKS!
|
|
02-21-2012, 07:26 PM
|
||||||
|
||||||
|
Quote:
|
|
02-22-2012, 06:37 AM
|
||||
|
||||
|
It much better to check it now than have to tear it down later.There's this word called regret that rolls around my beer soaked mind.Now Ive read that .030 to .080 are mins. for intake but if your around .060 all would be good. Exhaust is more some where around .0110. Im remembering this now you should check for sure though.
|
|
02-23-2012, 10:02 PM
|
||||
|
||||
|
valve to piston clearance
thanks guys i am not sure what cam to get yet though some people say not over .550 lift some say .650 lift what do you think?
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Piston to valve clearance | 1fast62 | Engine | 6 | 01-04-2012 06:35 PM |
| piston to valve clearance | lowandloud91 | Engine | 8 | 06-24-2009 11:51 PM |
| Valve/Piston Clearance | JohnyR17 | Engine | 2 | 02-20-2008 07:27 PM |
| piston to valve clearance | crazyman | Engine | 7 | 02-22-2004 03:52 PM |
| valve to piston clearance | Stinky | Engine | 5 | 06-13-2003 11:32 PM |
